Topic 4
Surface tension and capillary rise
The surface of a liquid behaves like a stretched skin. The pull along it, per metre of edge, is the surface tension S, in N/m. For water it is about 0.07 N/m. Dip a thin glass tube in water and this pull along the rim drags a column of water up inside the tube.
Predict first
Water rises 3 cm in a thin glass tube. How high does it rise in a tube of the same glass with half the radius?
Balancing the pull of surface tension round the rim, 2π r S cos θ, against the weight of the column, π r² h ρ g, gives the height. θ (theta) is the angle of contact between the liquid and the glass; for water on clean glass it is close to 0, so cos θ = 1.
h = 2 S cos θ / (r ρ g)
water in a tube of radius 0.7 mm: h = 2 × 0.07 / (0.0007 × 1000 × 10) = 0.02 m = 2 cm
Change the tube radius
- radius r
- 0.7 mm
- h = 2 S / (r ρ g)
- 2 cm
With S = 0.07 N/m and θ = 0, height times radius stays the same: 0.7 mm gives 2 cm, 1.4 mm gives 1 cm, 0.2 mm gives 7 cm. The tube width is drawn larger than to scale.
When the liquid falls instead
Mercury meets glass at an angle of contact of about 140°, more than 90°. Then cos θ is negative, h comes out negative, and mercury in a thin tube sits **below** the level outside.