Topic 1

What an AC meter actually reads

Before you start

You need Ohm's law, V = I R, and the fact that a resistor turns electrical energy into heat at the rate I² R. The only maths is a sine wave that repeats.

In an alternating current (AC) supply the voltage swings back and forth like a sine wave: v = V₀ sin ωt. Here V₀ is the peak voltage and ω is the angular frequency, ω = 2πf, where f is the number of cycles each second.

Averaged over a full cycle the voltage is zero, because it spends as long negative as positive. That average tells you nothing about heating. A heater warms up just as well while the current flows backwards.

Predict first

The mains supply in India is rated 220 V, and that rating is an rms value. What is the peak voltage?

The useful value is the root mean square (rms) value: the steady DC voltage that would heat a resistor at the same rate. For a sine wave it is the peak divided by √2. Meters and ratings give rms values unless they say otherwise.

Vrms = V₀ / √2 ≈ 0.707 V₀ Irms = I₀ / √2

rms voltage and rms current of a sine wave

Set the rms voltage and see the peak

3000−300peak 311.1 Vrms 220 Vtwo cycles →voltage (V)
rms value
220 V
peak = √2 × rms
311.1 V
average over a cycle
0 V

The rms line always sits at 0.707 of the peak, whatever the size of the wave.